External Flagpole Trucks sit at the top of each flagpole, providing an exposed pulley and rope system for raising and lowering the flag.
All Trucks are designed to accept Balls, Eagles and Finials. Standard Spindle Threading is 1-1/4″ NPT
Cap Design Trucks install over the top of the flagpole and are attached with anchoring set screws or bolts. Spindle Design Trucks incorporate a threaded spindle which is installed into a female fitting welded into the top of the flagpole. Stationary Trucks are fixed and will not rotate. Revolving Trucks rotate the flag with the wind.
Powder Coat Finish Options
BZT = Powder Coat – BronzeTone
BLK = Powder Coat – Black
WHT = Powder Coat – White
CLR = Powder Coat – Clear
• Cast Aluminum Body.
• Single Aluminum Pulley on Stainless Steel Axle.
• Upper and Lower Stainless Steel Ball Bearing Assemblies.
• 1-1/4″ NPT Spindle.
• 1/2″-13NC Top Drilling.
• Recommended Halyard Diameter – 5/16″.
Max. Shaft Top Diameter: 4"
This truck is only available with a 1-1/4" NPT spindle.